Periodic Maintenance of Edge Banding Machine
DAILY MAINTENANCE OF EDGE BANDING MACHINES
Ensure that your edge banding machine works together with a suitable dust collector unit during working hours. At the end of the working hours, coarse dirt should be cleaned by blowing air with the help of an air gun connected to the main air inlet on the edge banding machine. Make sure that any stuck parts that may be found between the units are cleaned. Wipe your machine, free of coarse dirt, dry with the help of a soft cloth. Since blowing air into the electrical panel may increase the risk of electrical problems, this process is not applied. Check if the edge banding machine vibrates, whistles, or has a strange odor after starting up. If there is any problem, try to find the source of the problem, if there is a problem caused by the environment, eliminate it, if the problem is caused by the edge banding machine, do not intervene and contact the authorized service after turning off the main switch and disconnecting it from the mains.
WEEKLY MAINTENANCE OF EDGE BANDING MACHINE
Since the edge banding machine‘s pallet works by rubbing on the slides, lubricating the pallets with suitable OIL for your edge banding machine will not force the redactor that rotates the pallet and chain and will provide ease of use. It is made from the grease nipples with the lubrication mark. The conditioner water tank traps water from the compressor. The water accumulated in this chamber must be drained.
MONTHLY MAINTENANCE OF EDGE BANDING MACHINE
Clean the inside of the edge banding machine from dust accumulated over time by using a dry air compressor. To protect small parts, pay attention to the pressure of the air used during cleaning. Check the screws on the edge banding machine, tighten if loose. If there is a missing screw, be sure to replace it with a new one. Replace the rusty screws with new ones. The places where the grommet and lubricator are located should be lubricated with suitable oils. The conditioner oil level should be checked and if there is a deficiency, it should be completed with the appropriate oil. The conditioner water tank traps water from the compressor. The water accumulated in this chamber must be drained. Compressor compresses the air we breathe and the water in the air breathed in the conditioner should be separated and accumulated in the water tank. If the water in the water tank is not emptied, it may cause corrosion in the pneumatic cylinders in the future. Your edge banding machine is out of warranty.
The suitable oil for your edge banding machine‘s brand should be used for the lubrication of the conditioner, Top-end, pallet system
In order to make sure that the existing cover switches are working before starting the machine and giving the workpiece, if the edge banding machine stops when you open the covers, the cover switches are working, if the edge banding machine continues to operate when you open the cover, the cover switches are broken. In this case, call the authorized service. Start the edge banding machine and ensure that the edge banding machine stops by pressing the EMERGENCY STOPs before giving the workpiece. In this way, the EMERGENCY STOPs and SIWICs of your edge banding machine are checked. Check whether it is working at certain intervals.
QUARTERLY MAINTENANCE OF EDGE BANDING MACHINE
Check that the actual current value given by the edge banding machine is the same as the current value adjusted with the potentiometer. The actual current value is measured with a clamp meter
